Colt Marlington
ArboristSite Guru
Sweet sweet CAD strikes again.
I've been planning to move out a few saws and upgrade my BIG/small saw with something sleeker and slimmer. And thought I had my heart set on a 241.
And then this little beauty fell in my lap.
I was not familiar with the 545, but it looked nice enough. And had the feel of a slender 40cc saw, reminiscent of a luxury hot rodded version of the CS-400 with a mag case.
A quick internet search told me that it was close enough to a high end saw, and too cheap to pass up.
It appears to be a low use saw with just a couple of garage dings. A little heavier than the 241, but more powerful. And slimmer than any 50cc saw that I've had my hands on.
Bar is 20" I think. So I'll put that away for when I need it, and probably pick up a new 16" b&c for it.
Pretty nice little saw from what I can tell.
I think I'm going to like it.
I've been planning to move out a few saws and upgrade my BIG/small saw with something sleeker and slimmer. And thought I had my heart set on a 241.
And then this little beauty fell in my lap.
I was not familiar with the 545, but it looked nice enough. And had the feel of a slender 40cc saw, reminiscent of a luxury hot rodded version of the CS-400 with a mag case.
A quick internet search told me that it was close enough to a high end saw, and too cheap to pass up.
It appears to be a low use saw with just a couple of garage dings. A little heavier than the 241, but more powerful. And slimmer than any 50cc saw that I've had my hands on.
Bar is 20" I think. So I'll put that away for when I need it, and probably pick up a new 16" b&c for it.
Pretty nice little saw from what I can tell.
I think I'm going to like it.