Degull
ArboristSite Lurker
Hi everyone. I have a Poulan Micro XXV that I bolted on a cylinder/piston from a Poulan 180 Pro. It bolted right up and fits very well (the 180 is a two ring design so I thought I see how well it would work). I'm have a strange problem. The saw runs well when it is on the ground level but if I tilt it forward the RPMs increase then when I bring it back level it cuts off and dies? This is only happens while the engine is idling. I tried a different carb and the same thing happens. At first I thought I had a vac leak somewhere, so I inspected it pretty close and could not find a problem. Anyone heard of this before?