Huskybill
Addicted to ArboristSite
please I’m looking for the guys who do porting not novices. I had the husqvarna ported rep piston and cylinder in my hand. I was all over it measuring it before I assembled the saw. The exhaust port was raised 1/8” and the intake port was lowered 1/8” when comparing it to a stock cylinder.
Don’t try this at home. I also noticed the piston skirt was cut 1/8” shorter? What do you gurus think that does on the bottom of the piston in relationship to the lowered and raised ports?
Cutting the piston skirt, it does nothing to the exhaust port, but influences the intake. Do you think the intake port can open too early?
Please no peanut gallery hackers it’s strictly business.
Don’t try this at home. I also noticed the piston skirt was cut 1/8” shorter? What do you gurus think that does on the bottom of the piston in relationship to the lowered and raised ports?
Cutting the piston skirt, it does nothing to the exhaust port, but influences the intake. Do you think the intake port can open too early?
Please no peanut gallery hackers it’s strictly business.