Sachs-Dolmar 120 Super!!!

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

z4lunch

ArboristSite Guru
. AS Supporting Member.
Joined
Jun 21, 2002
Messages
902
Reaction score
113
Location
WI
Steve here...
Ran that Super I bought on Ebay, last weekend($186US shipped)...After I went through it. Made sure it had no issues. Really clean runs good,cute little saw.. bout the size of a 372 or an 044...It's 4.1cu.
Cut a best of 4.75 sec in a 12 inch pine log, with square chain. My new066 was at 3.0 and the 088KD was at 2.2, till I noticed the oiler wasn't working.
I'll try to post some pics later
Steve
 
Once you go black theres no turnin back

Steve
I have been waiting for you to come out of the closet.Welcome to the Dolmar fan club. I have been quiet here on ABS cause the 7900 keeps dragging me back into the bush,but I keep plugin away ,tring to break it. The master Ken Dunn wants to see the inside so, I will ship it when I find the right box. Seth

I have a few 10x10 Aspen cants for tymed cuts. Lets get togther and race saws here in Boaz(It's not a place, It's a state of mind)
 
??????

Pix show a Husky branded bar, usually made by Oregon, or Windsor

Dolmar 120 Supers used an Oregon #095, Windsor # CJL.
Only a few Husky saws used that bar mount.

Most Huskys have been using a Oregon #009, Windsor #EM/HP.

Tail taper, , chain-sprocket angle, and oil holes will not match when installed.

Perhaps that is why the oiler doesn't seem to be working.

Good saw.
 

Latest posts

Back
Top