Hi all.
My beloved saw... stihl 024 started doing that "running for a few seconds and dying" thing a few months ago....
I've had this saw for over 25 years now and love it... its been amazing.....
Ive stripped it down to replace the impulse line..
Fitted a new Waldron carb.
I rebuilt it and it still doesn't run....
When I was trying to start it the other day fuel was being pushed out through the rubber "one way" breather plug at the top of the fuel tank...
Could there be too.much pressure?
With easy start it runs for a second and then dies...
Do I need to adjust the carb or are they set in the factory?
What settings should I adjust it to?
The coil gap i set at about .75-1mm
The spark seems bright...
Ideas?
My beloved saw... stihl 024 started doing that "running for a few seconds and dying" thing a few months ago....
I've had this saw for over 25 years now and love it... its been amazing.....
Ive stripped it down to replace the impulse line..
Fitted a new Waldron carb.
I rebuilt it and it still doesn't run....
When I was trying to start it the other day fuel was being pushed out through the rubber "one way" breather plug at the top of the fuel tank...
Could there be too.much pressure?
With easy start it runs for a second and then dies...
Do I need to adjust the carb or are they set in the factory?
What settings should I adjust it to?
The coil gap i set at about .75-1mm
The spark seems bright...
Ideas?