Hi, hoping someone here can help me with my incompetence, I'm new to working with Stihl equipment and was ask to recommision an old 038 AV Super that had sat for a while.
long story short I've battled ignition issues and replaced the carb (Bing48A101) with a tillotson model.
It starts and runs well for a good few minutes, free revving but then will stall out and die, when I attempt to restart it it will cough and run for a second then die again.
Coil readings (0.2 Primary, 9.3K Secondary), its had a replacement coil wire too. I have been messing with this for a good few hours now and not sure if I should be spending anymore time on it and sending it off to the sky.....
long story short I've battled ignition issues and replaced the carb (Bing48A101) with a tillotson model.
It starts and runs well for a good few minutes, free revving but then will stall out and die, when I attempt to restart it it will cough and run for a second then die again.
Coil readings (0.2 Primary, 9.3K Secondary), its had a replacement coil wire too. I have been messing with this for a good few hours now and not sure if I should be spending anymore time on it and sending it off to the sky.....