thooks
ArboristSite Lurker
I bought (and paid too much for) a fairly new 192T off of CL yesterday. It is a very clean saw, obviously not much use but the chain that is on the bar is dull as a butterknife and there's one laying in the case in the same shape.
It took several pulls to get it cranked (the guy selling it says it has been sitting in the case after only being used 2-3 times) but it will crank fairly easy with the high throttle position. It will not crank in normal throttle position when hot and it will not stay idling. It runs weak when at full throttle when hot.
Air filter was pretty clean. Took the plug out and it is brown on the ceramic, gap is very tight and cleaning it with sandpaper didn't help.
What are the possible causes?
I knew I should have just went and bought a new one. Karma will visit this AH that sold me this saw like this!
Thanks for any info.
It took several pulls to get it cranked (the guy selling it says it has been sitting in the case after only being used 2-3 times) but it will crank fairly easy with the high throttle position. It will not crank in normal throttle position when hot and it will not stay idling. It runs weak when at full throttle when hot.
Air filter was pretty clean. Took the plug out and it is brown on the ceramic, gap is very tight and cleaning it with sandpaper didn't help.
What are the possible causes?
I knew I should have just went and bought a new one. Karma will visit this AH that sold me this saw like this!
Thanks for any info.