I just put a new jug and piston on my newly boought 360 and wanted to start it up but, It has no clutch bearing. If I take off the sprocket is it safe to idle the saw or should I wait till the bearing comes in?
Also what is the proper break in procedure for a new top end? this is my first with new parts. I did another saw with a used top end and it worked great but I wasnt worried about the break in because it was already broke in.
Thanks, Nick.
Also what is the proper break in procedure for a new top end? this is my first with new parts. I did another saw with a used top end and it worked great but I wasnt worried about the break in because it was already broke in.
Thanks, Nick.