pablo.ramos47.pr
ArboristSite Lurker
Sorry in advance if posted in wrong part of forum,
Im working on this blower that floods out after a few pulls, I ran a couple tests(carb and seal tests) and Carburetor tested bad went ahead and replaced carburetor.
Since replacing the carb I've :
-replaced spark plug(properly gapped),
-run compression test(130psi)
-Tested for spark
-took off muffler (was full of fuel )
-Ive blown out all fuel in engine to try to unflood
-tried to start without fuel filter and without air filter
-piston/cylinder are not scored rings look good too
-new carb passed both pressure and vacuum test
I ran out of ideas on why it won't start
Any ideas are welcome, or if I can get pointed in the right direction I'd really appreciate it
Thank you for your time
-Pablo
Sent from my XT1585 using Tapatalk
Im working on this blower that floods out after a few pulls, I ran a couple tests(carb and seal tests) and Carburetor tested bad went ahead and replaced carburetor.
Since replacing the carb I've :
-replaced spark plug(properly gapped),
-run compression test(130psi)
-Tested for spark
-took off muffler (was full of fuel )
-Ive blown out all fuel in engine to try to unflood
-tried to start without fuel filter and without air filter
-piston/cylinder are not scored rings look good too
-new carb passed both pressure and vacuum test
I ran out of ideas on why it won't start
Any ideas are welcome, or if I can get pointed in the right direction I'd really appreciate it
Thank you for your time
-Pablo
Sent from my XT1585 using Tapatalk