tomdcoker
Addicted to ArboristSite
I have the above saw that I have rebuilt. I got it a couple years back with a scored P & C. It came from a construction company and I was told that it was straight gassed.
I cleaned up the cylinder and replaced the piston and rings. I have pressure and vacuum tested it twice and it passed. When I try to crank it I have to prime it. It will crank and run WOT until it runs out of gas (one second maybe then die). It does not pull any gas into the carb. I know that I am missing something, but I have been completely through it twice. T he carb. and manifold are a pain,, but I think everything is right. Notice I said " I think". This is not my first rodeo. but I am at a loss on where to go next. Any help would be appreciated. Tom
I cleaned up the cylinder and replaced the piston and rings. I have pressure and vacuum tested it twice and it passed. When I try to crank it I have to prime it. It will crank and run WOT until it runs out of gas (one second maybe then die). It does not pull any gas into the carb. I know that I am missing something, but I have been completely through it twice. T he carb. and manifold are a pain,, but I think everything is right. Notice I said " I think". This is not my first rodeo. but I am at a loss on where to go next. Any help would be appreciated. Tom