What products do you recommend to repair stripped spark plug threads? Do they last?
I have 3 decent cylinders if I can repair them.
I have 3 decent cylinders if I can repair them.
stripped spark plug threads
- Thread starter GeorgiaVol
- Start date
Help Support Arborist Forum:
- Joined
- Dec 4, 2016
- Messages
- 1,815
- Reaction score
- 2,780
I've only done one and it was for a generator. I used a timesert and it has held up well so far. The downside is they are expensive.
Buy yourself the Helicoil “Save A Thread” kit.
I’ve used mine on several cylinders and had to buy another batch of inserts. [emoji2960]
I’ve used mine on several cylinders and had to buy another batch of inserts. [emoji2960]
Take to a good machine shop if you get it slightly crooked it wont seal! Unless you think you are real good.
I will look into that. Thanks!
I can't afford the Time sert kit.
I can't afford the Time sert kit.
I have a few throwaway cylinders I can practice on. It would just suck to throw away a decent cylinder just because the plug is stripped
Like I said!
Yes, but I'm the kinda guy that would rather learn how to fix it himself then pay someone else to do it. I'm not talking about a rare old cylinder. I wouldn't risk something that would be difficult to replace.
Well it depends how straight you get it. Time serts are real nice.
are there any cheaper inserts that are like Time serts?
- Joined
- Dec 4, 2016
- Messages
- 1,815
- Reaction score
- 2,780
I always get frustrated when people cheap out no offense! Why do you want cheaper when you can get better do it right! Helicoils are cheaper yes. The Time Serts are not too expensive just buy the insert and use a different installing kit I have one.What size cylinder the 200T size are a *****?
Like that yes! And then odder the right size Time Serts for extra inserts! And GV how will you know once you do a test if the cyl will hold pressure?
Ok, Yes the install kit is what I meant.
I will try it on a cheaper saw first. I have a Husky 136 I could make my first attempt. No big loss if I mess it up.
Thanks for the advice!
Thanks for the advice!
See of you can get Copper ins
Like I said wow will you know it holds pressure you going to mount it up and pressure test?
Yes, I will use the cylinder and run the saw. I could always use another small saw.
Nope you need to pressure test it and spray the plug with soapy water first. Lot of people dont and think they fixed it
!
cuinrearview
Red saw lover
I'm 0 for 1 on the Save a Thread inserts. The upside is I gained a spare set of un-baffled transfer covers
What happened?I'm 0 for 1 on the Save a Thread inserts. The upside is I gained a spare set of un-baffled transfer covers
