Suggestions?

[fubar2]

Ok I take the bar off my old Husky and notice the adjusting screw is missing. I go to my screw drawer and find another. Start to put it back together and it hits me. How do I keep this one from viberating out? Thought about zapping the last thread with wire welder or hitting it with cold chisel. What is the accepted method?

 

[Jacob J.]

Ok I take the bar off my old Husky and notice the adjusting screw is missing. I go to my screw drawer and find another. Start to put it back together and it hits me. How do I keep this one from viberating out? Thought about zapping the last thread with wire welder or hitting it with cold chisel. What is the accepted method?

There's a rubber ring that goes over the tensioner screw and keeps it in the case.

 

[fubar2]

There's a rubber ring that goes over the tensioner screw and keeps it in the case.

Mine has disapeared. Im going to have to use more violent means.

 

[VTMan]

Plumbing teflon tape should work.

 

[Dan_IN_MN]

Epoxy...nail polish...

Epoxy...nail polish...

Something that will allow you to remove it if needed.

Dan