Sold my ssHD and ordered a SS SE with out work table and no motor. Made it wider than the oem table. Same length.
My father's been a welder forever. International Harvester over 40 years. All materials. At 78, he still makes it look easy! Design and fabrication are second nature.Holy hell, that's a great job! Man that would save me a hell of a lot of bending on my splitter I tell ya. Now I have to learn how to Weld and get metal. I was going to buy this side table of fleabay but doesn't look like it will hold up.
Sold my ssHD and ordered a SS SE with out work table and no motor. Made it wider than the oem table. Same length.
Because I lost my little fingers fingernail on the one with the side. Hit it at the Missouri charity cut this spring. I did put a small round on the side to stop pieces from rolling off. Fingernail is half grown back now.Hell to the yes .....
Why no lips on the sides?
Flashback! It is a sharp edged pinch point..Because I lost my little fingers fingernail on the one with the side.
Because I lost my little fingers fingernail on the one with the side. Hit it at the Missouri charity cut this spring. I did put a small round on the side to stop pieces from rolling off. Fingernail is half grown back now.
Pinch point where edge sticks up on side.Flashback! It is a sharp edged pinch point..
Because I could tell the difference in HD vs SE. Plus I could not find a way to make the fly wheels on the HD heavier.Makes sense. Why did you get rid of the HD?
What kind and size of wood do you split.Because I could tell the difference in HD vs SE. Plus I could not find a way to make the fly wheels on the HD heavier.
Enter your email address to join: