diesel3408
ArboristSite Member
Step 1Make sure that the chainsaw is turned off. To be on the safe side, disconnect the spark plug wire from the chainsaw engine, making it impossible to accidentally turn on. If you cannot locate the spark plug wire, refer to the technical diagrams in your chainsaw's user manual.
Step 2Loosen the chain adjustment knob on your chainsaw until there is enough slack on the chain to allow you to slip it off of the guide bar. Completely remove the chain from the saw.
Step 3Create a mixture of one cup of household ammonia and one gallon of water in a plastic bucket. Soak the chain in this solution as you carefully scrub one section at a time with a soft bristled brush. Continue soaking and scrubbing until the chain sparkles and appears to be grit-free.
Step 4Rinse the chain thoroughly under running water. Dry it immediately with an old but clean towel, making sure that all of the moisture has been sopped up before you proceed.
Step 5Lay the chain in a plastic tray and pour some bar and chain oil over it until the chain is at least halfway submerged. After about three hours of soaking, turn the chain over to soak the other side. After this final soak, lift the chain out of the oil and let the excess drip off into the tray. Lightly dab the chain with clean paper towels until it no longer drips, then reinstall it on your chainsaw.
Step 2Loosen the chain adjustment knob on your chainsaw until there is enough slack on the chain to allow you to slip it off of the guide bar. Completely remove the chain from the saw.
Step 3Create a mixture of one cup of household ammonia and one gallon of water in a plastic bucket. Soak the chain in this solution as you carefully scrub one section at a time with a soft bristled brush. Continue soaking and scrubbing until the chain sparkles and appears to be grit-free.
Step 4Rinse the chain thoroughly under running water. Dry it immediately with an old but clean towel, making sure that all of the moisture has been sopped up before you proceed.
Step 5Lay the chain in a plastic tray and pour some bar and chain oil over it until the chain is at least halfway submerged. After about three hours of soaking, turn the chain over to soak the other side. After this final soak, lift the chain out of the oil and let the excess drip off into the tray. Lightly dab the chain with clean paper towels until it no longer drips, then reinstall it on your chainsaw.
