At the flywheel.Via cylinder porting or at the flywheel?
Yes, the key is just there to hold it in alignment when the nut is tightened. It's the taper that keeps it in position.What keeps the flywheel from moving around? Just the tightness of the flywheel nut
Cool, I'm gonna try it out as soon as i can get out to the garage.
Already have one, santa came by with a few saws i wanted. i wish it wasn't so freekin cold. it takes to long for the garage to warm up when its 9 degressI realize its sacrilegious but isnt't this a perfect excuse to use that new impact gun you got from Santa ?
I thought about it but id have to run to the garage for toolsTime to bring in the saws and work them over on that new coffee table.
Better hold on to that flywheel real tight!I realize its sacrilegious but isnt't this a perfect excuse to use that new impact gun you got from Santa ?
pssst. don't tell anyone but it's real easy to hold a saw by the flywheel. unless ya got really girly handsBetter hold on to that flywheel real tight!
how much are you taking off the fly wheel? 30 to 40 thousands.how much will it advance.are all saws the same 044,064 .etc.
Enter your email address to join: