Truck frame repair

[Joedangelo04]

Hi, I had a minor accident but bad enough to bend over my f bumper brackets. They are I think 3/16 steel. Any suggestions how to straighten them or do I have to start fresh? Thanks

 

[blades]

if they are bolt on ones just replace ( can't tell from pic), save the headaces.

 

[ken morgan]

bolt on's, then swap them as they are part of the crush zone.. non bolt on break out the rosebud and a hammer and hydro spreader and get busy. a tape measure and a square will go a long way to getting them straight.