Jeffgithighintreez
ArboristSite Lurker
Thank You !!! I'll try this in the morningLook at page 3 it has carb settings
Sent from my LGMP450 using Tapatalk
Thank You !!! I'll try this in the morningLook at page 3 it has carb settings
The compression is about 135 psiYou may need seals.
I hope not !!! I paid $75. for it [emoji19]Or gotta bad carby.
I prefer Manatee's here in Florida [emoji13]
I believe it's a WalbroLol. I don't trust them. (Seals)
I took the limiters off this Walbro carbSounds like a cheapo Chinese carb with an out of round throttle plate....
Nope , I don't even think that it's possible ??If the carburetor is oem id guess it's probably ok. Either it's not adjusted right or you have an air leak. Is it possible you bent the throttle linkage?
Thanks for taking the time. I'll try and adjust it again tomorrow [emoji19]Nope , I don't even think that it's possible ??
Sent from my LGMP450 using Tapatalk
I don't remember it having a vent(grommet) ???Check the fuel grommet and lines.
PossibleSounds like a cheapo Chinese carb with an out of round throttle plate....
I thought that you were talkin' #14
TrueThat is the tank vent. 13 is the grommet for the tank vent.
Nearly everything in that diagram could be your culprit.
Enter your email address to join: