Your favourite rebuilding tool?

[Jasonrkba]

If my American bulldog is barking you better go see what it is. My idea of most used tool probably changes by the modle. Sockets maybe.

 

[president]

stihl work stand.invaluable for moving your powerhead
in all directions ,even upside down

 

[Stihlman]

Homade crank installation tool. Pulles the crank right into the case, made it so much easier. I used 3/4 all thread and threaded one m12x1 LH thread and the other m10x1 RH and that will do both sides of a lot of still cranks. Then run a nut up on it and I have that bolted to a handle them use proper spacer to cover bearing race and depth clearance, thread into crank, use handle to have leverage from turning and tighten nut and pulles the crank right in. Works great for me.

Sent from my VS995 using Tapatalk

 

[Huskybill]

I purchased most of the Husqvarna assembly and disassembly tools life is much easier now.

 

[angelo c]

Stihl T27 t handie driver....
And my torch

 

[Vintage Engine Repairs]

My boys are harmless, just noisy! This was after a bath, have to make em sit still so they don’t rub all over the carpet!View attachment 843480

Ah yes, bath time is my dogs favourite... not!

 

[Jasonrkba]

I'm usually just as wet as the dog after bath time.lol

 

[Totembear]

Mattyos crank assembly tools. They make life alot easier. Then my torch.

 

[lone wolf]

Mattyos crank assembly tools. They make life alot easier. Then my torch.

Good guy Matt .