What compression reading do you think I will get if i clean that cyl and put a new piston in?MS200 cylinders generally clean up fine,, work on the cylinder, put a new piston in it, vac and pressure test and then tach it and all will be good!
150-160 going up to 170 after a few tanks. If you drop the base gasket, you may see 200 if you are lucky. A lot depends on what type of gauge you test on, these are from a tested with a Schrader in the tip of the tester hose.What compression reading do you think I will get if i clean that cyl and put a new piston in?
Nope its yours alright you had your name on it.Dang - are you sure you didn't swap my saw with a new one? It looks so good I won't recognize it when I get it back!
Thanks for doing such a great job.
Unc , post 13 is the guy Dave I told you that can get you the brake handle part you need.Dang - are you sure you didn't swap my saw with a new one? It looks so good I won't recognize it when I get it back!
Thanks for doing such a great job.
Unc , post 13 is the guy Dave I told you that can get you the brake handle part you need.
Brake handle repairs are almost as much fun as rebuilding a 200t !!!!
+1 on "ddave is a parts slut " and all around good dude too .
Enter your email address to join: