Saws that surprised you...

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
did it have a pop up?


Tigerloff (was the scandal) Randy was the builder. He built him that saw. Tgerloff got it back and then went in it and a 5100 Randy did as well. DexterDay wound up with the saws, he sold them, both saws wound back up in Dex's possession and back in Randy's shop and became the infamous "Tgerloff blue goo" saws. Randy redid the 395, and Dex was trying to trade for a 441cm on here, I asked him what he could buy a 441cm for, and paid him that for the 395xp. I dont know if having Randy in the saw twice contributes to how strong the saw is.... but it couldnt have hurt anything. The saw is rediculous.
 
Really? I read where Wiggs had an interest in the 600p, but there wasnt much explanation to his interest.
randy ported mine and I carried it to the echo dealer and ran against a stock 600 and a 680 stock and their mouths dropped. that 60 cc is bad to the bone
 
For me its my 372. The first 372 I had was OK but this one is a freak. Compression is only 160 that I've read but with a 24 b/c its fast. Its out cut all my 70cc saws, at a buddy's small gtg it out cut his 441cm modded, a 7300 Dolmar, another 372,460 mag. My other 372 is 2 seconds slower in the same log and it has a new ring. Second would be my clean 262. It stays even with my 562 it blows 165.
 
Sawtroll 3....2....1 :laughing:

What there are 600p threads going on without me? Yeap they are impressive.everybody likes mine when i start it and it starts to crackle.i always run a 20" 70dl but for the hell of it i bought one of those 16" GB bars from left coast and put on a 33rc chain.was going to put on a 8 pin rim sprocket but i've misplaced it.it suprised me when i took off the clip and washer.i was expecting a small spline sprocket.
Yeap the 600p is awesome.don't know if its ms362 awesome but its definitely awesome.:laugh:
 
For me its my 372. The first 372 I had was OK but this one is a freak. Compression is only 160 that I've read but with a 24 b/c its fast. Its out cut all my 70cc saws, at a buddy's small gtg it out cut his 441cm modded, a 7300 Dolmar, another 372,460 mag. My other 372 is 2 seconds slower in the same log and it has a new ring. Second would be my clean 262. It stays even with my 562 it blows 165.

Does it have anything to do with your new 372 being a x-torq or is it the old version?
 
335xpt muffler mod and super shady bottom end work. I
Bought it off eBay and started tinkering with it. Replace crank bearings and while I was in it polished belly pan and lightly touched the ports to clean up. For what it is I can sunk the bar clean in oak ad it never misses a beat


Sent from my iPhone using Tapatalk
 

Latest posts

Back
Top