I have run a few of their bars. I have a pro 36, 28, 24 bar in 058 and they are very hard bars. So hard that they require very little filing on the cutting edge, and I mainly do milling.
I bent the tip on the 28 and to replace it was extremely easy. New tips with 6 rivet blends are inexpensive from baileys.
The biggest downside is weight they are heavy. I suppose no heavier than the others.
Their laminate bars hold up well but suck for oiling, I have had two 20” laminated bars, a farm tough in 3/8 050 and a grey laminate bar in .325 050. Light but like I said bad for oil delivery.
If you go with a laminate bar, I would highly suggest the Oregon speedcut (these are small mount). I have one in 18” with the speed cut chain and it is def an upgrade to the grey .325 laminate that husky sells. Chain and bar combo is very inexpensive also replacement chains very cheap.
I have not tried their versa cut, they seem to be large mount bars, but I would like to know if they are good.
My two cents