motoroilmccall
ArboristSite Guru
Well, the 044 is acting up. I dawg the saw in and start cutting, and the saw bogs out and stops cutting, this is with a 20" bar and 7 pin on it... Does the same thing with an 8 pin, or a 7 pin and a 28" bar...
Compression is at 140-145psi cold, 130-135 hot... I'm thinking its time for a rebuild. It still seems like its cutting fine if you don't dawg the saw in, but as soon as you do it'll bog out. Never quite had a saw act like this, so I figured there's a decent chance someone here has. Any ideas fella's?
Compression is at 140-145psi cold, 130-135 hot... I'm thinking its time for a rebuild. It still seems like its cutting fine if you don't dawg the saw in, but as soon as you do it'll bog out. Never quite had a saw act like this, so I figured there's a decent chance someone here has. Any ideas fella's?