Trever
GB mill 076 Super Stihl
First off, the flywheel adapter and drill tool are my employee's idea. A real good I might add. I am using an old 075 to mill with, and I have problem after problem with the old style starter system. Finally decided on thinking outside the box with my employee's help. I kept the fan housing on to cool the cylinder, but removed the gas tank. You can do this on the old starters (050,051,075) but not the newer style 051s, 076, TS 510, and ts 760 fan/ starter housings. I run a 44" GB double ender CSM with just the one power head.
The idea was to start my saw with a cordless drill, and run an external fuel tank. You need at least a 18 volt fully charged to turn it over without a decomp valve. I plan on removing my cylinder plug and installing the decomp valve to keep from wearing out the drill. As far as the fuel tank goes, I plan on using a 1 1/2 gallon plastic tank mounted to the mill.
Who has done this already? Thank you and I will post more pictures as I figure this out. Have a blessed day.
The idea was to start my saw with a cordless drill, and run an external fuel tank. You need at least a 18 volt fully charged to turn it over without a decomp valve. I plan on removing my cylinder plug and installing the decomp valve to keep from wearing out the drill. As far as the fuel tank goes, I plan on using a 1 1/2 gallon plastic tank mounted to the mill.
Who has done this already? Thank you and I will post more pictures as I figure this out. Have a blessed day.