372xp dawgs/spikes
- Thread starter benjy
- Start date
Help Support Arborist Forum:
Freyboy23
ArboristSite Guru
I Made my own. its worth a try if you can.
The factory big dawgs are only about $15 from Baileys. I don't know about shipping though.
well i did think about this..... what gauge steel did you use and did you just use a bandsaw to cut it?
I have a friend that makes them from circular saw blades.
Grande Dog
ArboristSite.com Sponsor
Howdy,
Here's the set Brad was talking about:
Bailey's - Heavy Duty Felling Dogs for 365, 371, 372, 385, 570, 575
It's cheaper than what Husqvarna wants for the OS dog by itself.
If you happen to order them online, put a note in the comments for us to ship them in the small flat rate box. It's the cheapest way we would have to get them to you. The shipping would be about $13.00 - $14.00 USD
Regards
Gregg
Here's the set Brad was talking about:
Bailey's - Heavy Duty Felling Dogs for 365, 371, 372, 385, 570, 575
It's cheaper than what Husqvarna wants for the OS dog by itself.
If you happen to order them online, put a note in the comments for us to ship them in the small flat rate box. It's the cheapest way we would have to get them to you. The shipping would be about $13.00 - $14.00 USD
Regards
Gregg
Just FWIW there are two different sets of spikes for the 372 family of chainsaws from Husqvarna.
Both sizes have inner and outer pieces. One is the standard "XP" set and then there is the "XPW" set which is much larger
Outer Wrap 503 92 27-01
Inner Wrap 537 01 72-01
These are the Standard spikes in the USA
Outer XP 503 71 97-01
Inner XP 537 01 71-01
Chain catcher parts that go in the bottom of the spike. The saw will not set correctly on the ground without these fro the spike will sink in the dirt and leaves.
Steel spindle 537 08 92-01
Plastic roller 537 02 44-01
Bolt 503 20 02-30
Nut, self locking 503 22 24-01
There is a sheet metal screw that holds the outer spike in place when you remove the bar nuts
503 21 28-10
Both sizes have inner and outer pieces. One is the standard "XP" set and then there is the "XPW" set which is much larger
Outer Wrap 503 92 27-01
Inner Wrap 537 01 72-01
These are the Standard spikes in the USA
Outer XP 503 71 97-01
Inner XP 537 01 71-01
Chain catcher parts that go in the bottom of the spike. The saw will not set correctly on the ground without these fro the spike will sink in the dirt and leaves.
Steel spindle 537 08 92-01
Plastic roller 537 02 44-01
Bolt 503 20 02-30
Nut, self locking 503 22 24-01
There is a sheet metal screw that holds the outer spike in place when you remove the bar nuts
503 21 28-10
Last edited:
You simply cannot beat this deal. These are significantly larger than stock and come with the roller chain catcher as well. For $30, you can't go wrong!
Here they are on my 372XP.
deranged
ArboristSite Member
I'm going to assume that I have a set of the dogs from Bailey's, :msp_tongue:, and they are very nice. Muy bueno.
