You will have to send the saw to me
So I can look it over for while , long while [emoji4]
When I slip the carb into the saw...it is clear that the hi screw is too far out...it smashes up against the plastic.
My two guesses...threads bunged up, debris down deep in the skinny part of the hole (the 4mm part of the hole looks fine).
Suggestions? Chase threads in carb body? Is there some way to blow out that hole from the inside-out?
Roy
You sure it is the correct screw? I would not be surprised if someone had tried to cobble it together with another H screw. It maybe just easier to swap out the carb in the end.
IF IT HAS A NOZZLE CHECK VALVE DONT BLOW OUT THE HIGH NEED TO HOOK TO THE NOZZLE CHECK VALVE AND U WILL BLOW OUY THE NOZZLE DISC. If it has a accumulator cover than your good
To=its
Enter your email address to join: