Homelite super mini with the dreaded blue coil.has anyone come up with a suitable replacement or a means of a workaround.i've had success with the heat treatment but it only lasts for a couple of days.i'm thinking that once I get a good spark I may dip the whole coil in varnish which should seal everything.Any pros/cons would be appreciated.
Homelite Chainsaws
- Thread starter briantutt
- Start date
Help Support Arborist Forum:
Trying to fix up an original ez saw for my dad. Trying the get to the coil but I'm struggling to figure out how to get the recoil off. I don't want to take something apart and be in worse shape than when I started. Thanks fellas
I found a Leon's video of them reinstalling one. Wow that's an interesting set up 
Once you relieve the spring tension by unwinding the rope, everything unscrews and lifts off the crank. 4 screws on the pulley. 4 screws for the screen and spring holder. 1 crank nut and 3 base screws for the overrunning starter. Pay attention to the order of the washers and shims when you pull it apart. Run a zip tie thru the whole mess. I only had one I had to repair with new parts. The starter was pretty beat to crap. Grease the bearings when you reassemble.
Thanks CB! I've only messed with remingtons, this one is quite a bit different. Thanks so much for the knowledge. Much appreciated
Homelite was proud of this ratcheting type starter. Used it for years. They came out with an overunning bearing type in the mid 60s along with FM starters. Eventually, they went to a pawl type like everybody else in the 70s.
A la Briggs & Stratton and stale Alec Baldwin Christmas delights.
Dang 
I got down to the flywheel but will need to fab up a puller. This homelite is getting complicated . I may not be able to put it back together again, gonna be the Humpty Dumpty saw or end up a basket case
I got down to the flywheel but will need to fab up a puller. This homelite is getting complicated . I may not be able to put it back together again, gonna be the Humpty Dumpty saw or end up a basket caseAsk someone to send you a IPL. They are a pretty straight forward saw. Just do not lose any fasteners as they are replaceable but the china special ones will be out of place. The little screws holding the shroud on are interestingDang
Glad to see someone picked up on my subtle reference.
Dang
Use a harmonic balance puller and long 1/4" nc bolts, at least 4" long. No need to fab anything and you'll use the puller again.
Not all of the info you find on the internet about chainsaws is correct, if you search the Homelite 240-HG you may find it listed as first being made in 1986, that information is wrong. I bought my first ever chainsaw from Kmart in the fall of 1981, it was a Homelite 240. Here’s all I have left, the manual was printed in 1981.
Attachments
Still have the saw?
I don't, I wore it out several years ago. I used it as a limbing saw and either my 3400 or 3700 poulan for the bigger cuts. Mine had a 16" bar, it cut pretty good for what it was.
