Sounds to me like I should just keep 'er stock for the time being.
That is up to you. My 359 runs like a stock 372XP.
Sounds to me like I should just keep 'er stock for the time being.
Sounds to me like I should just keep 'er stock for the time being.
If the mod approach stays within the recognized guidelines for a work saw, you are OK. Still, you should run a modified saw with some discretion, that is not to fry the thing running a dull chain, and pay attention that the carb setting is not too lean.
Recognized guidelines??????????????????
You mean the BS that people have repeated enough times that people accept as fact. It doesn't matter if it is true....everyone says it.
Fred
No...or yes, depending in what you are referring to. C'mon Fred, there are a few givens on the matter that don't require an electron microscope to sort out, or saws would be burning up big time all over the place, or at least wouldn't start or run worth cra@. What I had in mind by my post, is what I have found that works with my own saws, and I believe that for the most part, these same considerations are what has proven successful for other folks as well, who run modified work saws. I also realize that other aspects are more open to debate....and the learning process goes on. Do you want to question my own basis for reliability....if so, drive out to the woods where I am working, and at break time I will shut off the saw and we can talk about it. First you have to fly over here though. Why be so friggen negative, man?
Yes Fred, everyone here isn't an accomplished saw builder, but there's a lot of good factual information on the 359 available on this site.It just my pet peeve. I really do believe that WHO does the modifications is just as important as what modifications are done.
I know I've seen some terrible exhaust ports posted on this site.
Fred
Yes Fred, everyone here isn't an accomplished saw builder, but there's a lot of good factual information on the 359 available on this site.
If nothing else a simple muffler mod does wonders. Agree?
Exactly, Even a muffler mod could seem like a big step for some.Absolutely.
I just don't think that porting should be the first thing we throw at people relatively new to this addiction.
Fred
Exactly, Even a muffler mod could seem like a big step for some.
+1 on getting a non cat muffler! I have a 2159 the hot red headed sister to the 359 my favorite saw! It started out life for two tanks with the cat muffler. I turned the saw off to move some blocks that I had cut.Buy the non cat muffler. It's the best $40 you'll spend. You'll gain a little power but a lot less heat. It will give you great peace of mind when you notice how much quicker they cool off. You'll have to cut the plastic sleeve that goes around the carb screws and work it off with a pair of needle nose pliers. Get a rotary tool with a very small attachment and slowly grind the tabs off of the caps on the carb. adjustment screws. I would richen the H jet about 1/4 turn from even if just switching to non-cat without modding the muffler.
Enter your email address to join: