- Joined
- May 13, 2014
- Messages
- 709
- Reaction score
- 674
In light of the recent outages on Bill's saw shop site while they transition ownership (inspired by this thread), I decided to create a PDF list of the Husqvarna saw spec sheet since I reference it so often. I can do the same for Stihl if desired.
This is a draft while I gather feedback, once it is ready I can post again as a sticky. (What's the process to do this?)
I think it will have to be a PDF as I can't post an HTML table.
Attached the first draft.
-I added in the most common saws on the first page. I then left some duplicates on page 3 so it is still in model order. Does this make sense? So it is in order of 3, 1, 2 from Bill's.
-Optimized printable layout. Should print the whole page properly on nearly all printers
-General feedback on readability
-I was surprised the 346XP specs were incorrect... also added the N.E.
-Could not confirm max rpm for 550/562
-I added a torque column
-Is k.W. power column adding any value? I may remove and leave HP only.
-Is it valuable to add the year a saw was first released? (not sure I have room)
Thanks...
This is a draft while I gather feedback, once it is ready I can post again as a sticky. (What's the process to do this?)
I think it will have to be a PDF as I can't post an HTML table.
Attached the first draft.
-I added in the most common saws on the first page. I then left some duplicates on page 3 so it is still in model order. Does this make sense? So it is in order of 3, 1, 2 from Bill's.
-Optimized printable layout. Should print the whole page properly on nearly all printers
-General feedback on readability
-I was surprised the 346XP specs were incorrect... also added the N.E.
-Could not confirm max rpm for 550/562
-I added a torque column
-Is k.W. power column adding any value? I may remove and leave HP only.
-Is it valuable to add the year a saw was first released? (not sure I have room)
Thanks...