Husqvarna 2100cd Muffler Bolt

[G-Man!!!]

I have a 2100cd with two stripped out holes on either side of the exhaust port, the one on the clutch side of the saw is the worst, the one on the flywheel side can most likely be re tapped and work. What are my options, and what size bolt is it that goes through the muffler and into either side of the threaded holes of the exhaust port? TIA...

Also, does anyone have a few 2100cd muffler bolts they can spare?

 

[dynodave]

I have a 2100cd with two stripped out holes on either side of the exhaust port, the one on the clutch side of the saw is the worst, the one on the flywheel side can most likely be re tapped and work. What are my options, and what size bolt is it that goes through the muffler and into either side of the threaded holes of the exhaust port? TIA...

Also, does anyone have a few 2100cd muffler bolts they can spare?

I heli coiled back to original 6mm using a drilling jig.. The previous butchered 1/4-20 repair was real ugly.
http://www.arboristsite.com/community/gallery/albums/husqvarna-4.1358/

 

[G-Man!!!]

I heli coiled back to original 6mm using a drilling jig.. The previous butchered 1/4-20 repair was real ugly.
http://www.arboristsite.com/community/gallery/albums/husqvarna-4.1358/

Thanks, you wouldn't happen to know the measurements of the two bolts would you???

 

[dynodave]

finally found one in my 298xp basket case bucket.
70mm long/ 2.73"

 

[G-Man!!!]

finally found one in my 298xp basket case bucket.
70mm long/ 2.73"

Thanks...