ShneaSIG
ArboristSite Operative
Hi guys,
I ordered the double felling dogs and chain catcher kit through my dealer which is supposed to be for my MS 362c - parts kit # 1135-650-7750. For the install, everything appeared to be going fine, until it came time to pop the cover back on and put the whole works back together. Then, it became obvious that the roller catcher was too wide, and if I had tightened the bar nuts all the way, the dogs would be flexed out at the bottom and the cover wouldn't be seating properly.
I wound up disassembling, and with some trial and error, achieved a proper fit after removing about 1/8" (maybe a hair more) from an end of the roller catcher.
Did I get the wrong parts? Or is this something other people have run into?
I ordered the double felling dogs and chain catcher kit through my dealer which is supposed to be for my MS 362c - parts kit # 1135-650-7750. For the install, everything appeared to be going fine, until it came time to pop the cover back on and put the whole works back together. Then, it became obvious that the roller catcher was too wide, and if I had tightened the bar nuts all the way, the dogs would be flexed out at the bottom and the cover wouldn't be seating properly.
I wound up disassembling, and with some trial and error, achieved a proper fit after removing about 1/8" (maybe a hair more) from an end of the roller catcher.
Did I get the wrong parts? Or is this something other people have run into?