What are you thinking? Sounds like it's idling too high and throttle response doesn't sound that good, with relatively slow spool up. How's it cut?
l am not sure about your above post buzz but basically the auto tune is consantly recallibrating itself so after each modd you may want to put it in wood and make several loaded cuts so it can optimally set itself up. While Mtronic basically does the same job it does it differently. l think autotune uses rpm to regulate fuel delivery where Mtronic actually has a sensor to measure how rich/lean the fuel mixture is. Anyway the systems are different in the way they achieve a similar result. l think Mtronic is a better system myself than autotune however both systems seem to keep the saw tuned optimaly in ALL conditions and mix ratios.
Not very large and not a big change in port timing. The muffler had a very large outlet. I'll look for the videos on YouTube of it.How large were the ports on that one, ive got some big holes in this one as well as modified port timing so I pretty sure that little computer isn't quite sure what's going on, an now just about to put a custom ported muffler on also, so on the autotune is it an injector or a solenoid?
l am not sure about your above post buzz but basically the auto tune is consantly recallibrating itself so after each modd you may want to put it in wood and make several loaded cuts so it can optimally set itself up. While Mtronic basically does the same job it does it differently. l think autotune uses rpm to regulate fuel delivery where Mtronic actually has a sensor to measure how rich/lean the fuel mixture is. Anyway the systems are different in the way they achieve a similar result. l think Mtronic is a better system myself than autotune however both systems seem to keep the saw tuned optimaly in ALL conditions and mix ratios.
Enter your email address to join: