7sleeper
Addicted to ArboristSite
Dear community,
Since most of the information(pics, videos & links) is forever lost here since the linky debacle, I see myself obliged to open a new thread.
I am aware of using a dry wall screw to remove the "epa" caps but this model is more than resilient. It is on a walbro carb and I would like to remove it in a way as to reapply after correction. If I pull it I can only get it off 1-2mm. That's all. After that it just snaps in place and I could hang the saw from the limiter!
Any one an idea?
Here is a pic from the outside.
Thanks for the help!
7
p.s. it's about this saw
Since most of the information(pics, videos & links) is forever lost here since the linky debacle, I see myself obliged to open a new thread.
I am aware of using a dry wall screw to remove the "epa" caps but this model is more than resilient. It is on a walbro carb and I would like to remove it in a way as to reapply after correction. If I pull it I can only get it off 1-2mm. That's all. After that it just snaps in place and I could hang the saw from the limiter!
Any one an idea?
Here is a pic from the outside.
Thanks for the help!
7
p.s. it's about this saw