parrisw
Tree Freak
YIKES, reminds me of this!!!!!
Hey, trust me, I know it's a spooky setup. Like I said in my original post, I will probably never do this again because I now have the proper preset. I just wanted to see if I could make a once used preset work. It works. I don't usually wear a face shield here at the house, with this chain I'm wearing one. I've always been a bit of an envelope pusher. My other favorite hobby is rapelling through slot canyons in Zion Ntl. Park. Seen some serious timber in that back country.
What JJ said about landing saws is too true, very nasty. The only thing that I have seen that is worse are piling saws at the harbor.
Okay, I can't help it... I've had some chains jump the bar before but never break. I'm sittin here tryin to figure out the worst case scenario if it does.
If it's in the wood it's not going anywhere. If your revving it I guess it could end up against a body part below the saw. Doubt it penetrates the chaps though. You guys do wear chaps don't ya?
I think there's more risk from oiler holes and bar grooves plugging up and throwing chains and not wearing protection. Or getting crushed...
Have a safe day, woo
Enter your email address to join: