Search results

Husky 395XL, but good luck finding one of those. Like the 660, most people don't cut loose of them. Hit the pawnshops, you might get lucky.

I started with an alaskan mill, Granberg. Only part I hated was mostly working from your knees. I JUST dod a full day of milling on a Logosol M* Farmer's mill. Some really nice ash and red oak edging. It is worth every penny in my book. Not cheap but not a bandsaw mill either. I HIGHLY recommend...

The 660 or 066 are you best bets. They are out there. Just picked up a second one as a spare for 575 plus 25 shipping. Runs GREAT so it was a great deal. Craigs list, FB marketplace and other outlets, Pawn shops.... they are out there, just beat the bushes and you will find one. Post an ISO here...

Budget and needs/requirements/desires are the key factors we need to know. Otherwise it is just a bunch of "I have thistype...."

Justsaws I use a MS 660Magnum. Can you show me or point me in the right direction for a clutch cover mod or replacement for the 660?

Looking at a used MS391 for about 350.00. It is POST recall as the SE# is after the range listed on the Sthil website. Any thought on if that is a good deal?

Hey all, I see other asking so I thought I might. A Shop manual for a MS 020T please? Anybody know where I can find one?

I found the Carb part number in one of the pics above. Gonna try the rebuild kit first.

The IPL lists 3 different carbs, if I am reading it correctly, Anybody help me out as to which one I have for a rebuild kit, or would it just be better to get a whole new unit? Also on the Oiler Adjustment, am I reading the figure correctly and it should be in the center of the adjustment span...

$65.00 on a yard sale table with the bar and chain off of it. I think the oil cap and fuel cap are not sealing well so I just got some new ones. Local dealer has no fuel lines. Bailey's sell good stuff? I know that they are not authorized dealers but can I trust the parts and the carb re-build...

Other Carb Pics .....

Found this potential gem for a GREAT price. Started getting into her and have a few question. First, the Carb and it's adjustments and factory defaults. FSM shows three adjustments, High Low and Low Idle, I think they are. This saw only has 3 as shown in the pics. Did somebody switch out the...

Info on the sure shot sprayer please?

That is wrong on so many levels, BUT I LOVE IT!!!!!!! LMAO

I am a homeowner and getting ready to tear down a yard sale find (Stihl 020T). It is VERY dirty and needs a good cleaning, At least. Question about Parts Cleaners and the fluid you guys use in yours. Mechanic friend says some use Mineral Spirits and others use Diesel Fuel. One seams a whole lot...

Can anybody share a FSM for a Stihl 020T please?

I alway thought you use the same wood, if possible. But I am a bit puzzled at the use of Pressure Treated 4x4's as stickers. Isn't that a HUGE no-no?

Hey all, I purchased an already assembled Granberg mill (36") from a person who for health reasons could not use it after they owned it for a year or so. Can some body here post some pics of a PROPERLY assembled MKIII 36" Alaskan Chain Saw Mill please so I can compare what I have to what it...

So you think a pressure washer is ok for cleaning them up prior to milling?