good day all,
I have an older 011 avt that I am working on right now.
My knowledge on chainsaws is limited at this point but am quite passionate about these things and decided that the best way to learn about them was to get my hands dirty and working on them.
The Oiler was not working on it so I took it part, cleaned the parts in gas and it now works. The problem is that it seems to be liking too much when in operation. Also it drips oil from the oil orifice when sitting for a while.
Also, I rebuilt the carb on this unit as it would not start. Now it starts fine but I am looking for the max RPM for these saws or perhaps the safe adjustment of the H screw so I don’t end up damaging the engine.
Thanks for any help!
I have an older 011 avt that I am working on right now.
My knowledge on chainsaws is limited at this point but am quite passionate about these things and decided that the best way to learn about them was to get my hands dirty and working on them.
The Oiler was not working on it so I took it part, cleaned the parts in gas and it now works. The problem is that it seems to be liking too much when in operation. Also it drips oil from the oil orifice when sitting for a while.
Also, I rebuilt the carb on this unit as it would not start. Now it starts fine but I am looking for the max RPM for these saws or perhaps the safe adjustment of the H screw so I don’t end up damaging the engine.
Thanks for any help!