To woods port you just need a dremel, and double cut carbide burrs. To polish just a split mandrel for the dremel and sand paper. Personally I would also get a pencil attachment for the dremel. Could get all that on amazon for under $100. There’s gain to be had with just Woods porting but if you want serious gains you need to have a lathe.
Those ports look kind of rough. Just kidding, he does nice work. Had him do a 372oe and it runs nice and strong.
Don't start that follow the leader show over here. What he did was not right, but come on, let it go.Iron horse taught me...
Don't start that follow the leader show over here. What he did was not right, but come on, let it go.
066 tools?Don't listen to these snobby pricks @Jkstihl . All you need can be found at your local Home Depot.
View attachment 797536 View attachment 797537
Don't listen to these snobby pricks @Jkstihl . All you need can be found at your local Home Depot.
View attachment 797536 View attachment 797537
390xp. Plus a 4" angle grinder066 tools?
390xp. Plus a 4" angle grinder
Just remember, your saw may not run like it used to before you "improved" it.
Enter your email address to join: