nwmo_aggie
ArboristSite Operative
Lot of 3 saws, asking $250+transportation for the lot.
No issues with either running saw. Prefer to sell as complete lot. These are good running saws. Good antivibe systems. Saws all oil well, and chain brakes work. Currently tuned to run Stihl 40:1 and 91 octane. Always run Stihl bar oil.
Unknown age...older than 1985 based on SN. PM610. 60cc. Good Compression, starts as good as these ever did. Has been my main big saw. Yellow with black pull rope in pic.
1985 PM605. 55cc Runs good. A bit cold natured, but runs good once it's warmed up. Black with yellow pull rope in pic. Chunked up a lot of wood for me.
1991 PM610. No bar in pic. All parts there (gas tank in a box in cabinet) Saw was straight gassed at some point and has low compression. I bought it as a Low use saw, and it might have had either a replacement NOS carb, or a carb kit, I don't recall. I've had it running, but it won't pull a chain, I never pulled the muffler to look inside. Looks like a pretty low hour saw. Lots of good parts to keep the others going, or would be a candidate for a ebay Piston/cylinder, or 650 kit.
Still looking through cabinets, may come up with some other spare parts I don't need, I think there’s some air filters somewhere.
Make me an offer. Located in Northern MO, but occasionally travel to NE and IA
No issues with either running saw. Prefer to sell as complete lot. These are good running saws. Good antivibe systems. Saws all oil well, and chain brakes work. Currently tuned to run Stihl 40:1 and 91 octane. Always run Stihl bar oil.
Unknown age...older than 1985 based on SN. PM610. 60cc. Good Compression, starts as good as these ever did. Has been my main big saw. Yellow with black pull rope in pic.
1985 PM605. 55cc Runs good. A bit cold natured, but runs good once it's warmed up. Black with yellow pull rope in pic. Chunked up a lot of wood for me.
1991 PM610. No bar in pic. All parts there (gas tank in a box in cabinet) Saw was straight gassed at some point and has low compression. I bought it as a Low use saw, and it might have had either a replacement NOS carb, or a carb kit, I don't recall. I've had it running, but it won't pull a chain, I never pulled the muffler to look inside. Looks like a pretty low hour saw. Lots of good parts to keep the others going, or would be a candidate for a ebay Piston/cylinder, or 650 kit.
Still looking through cabinets, may come up with some other spare parts I don't need, I think there’s some air filters somewhere.
Make me an offer. Located in Northern MO, but occasionally travel to NE and IA