Stihl MS200T: is this cilinder toast?

[lone wolf]

That was easy lone wolf!
I turned back the H screw 1 full turn instead of 3/4 and the saw was fine after that. Maybe just a tiny little bit rich on WOT but hey, it's not a production saw.

Funny that it says 3/4 back on the saw. Why?

I'm happy with my old 200t up and running again!

Thanks everyone for the help on this one.

 

[grizz55chev]

That was easy lone wolf!
I turned back the H screw 1 full turn instead of 3/4 and the saw was fine after that. Maybe just a tiny little bit rich on WOT but hey, it's not a production saw.

Funny that it says 3/4 back on the saw. Why?

I'm happy with my old 200t up and running again!

Thanks everyone for the help on this one.

The #’s that are posted on the Saw for adjustment are starting points, good for getting the Saw running. Each saw will have different final settings after they’re set up. The best way to adjust the “H” is with the Saw buried in the cut.

 

[blsnelling]

unny that it says 3/4 back on the saw. Why?

That's nothing more than a starting point, after which it needs actually tuned.