romeo
Addicted to ArboristSite
These are various different bikesaws (five different saws to be exact), but a pic is worth a thousand words they say.
Last edited:
Also, if you look under the rear of the bar on the chassis in this pic, there is a grade 8 9/16" bolt running through and sticking out a few inches, that is to save your nutz, when chains derail they go down and back. Then a good strong chain guard on the top of course.This pic Romeo posted shows a chain catcher. As long as the chain loop stays in one piece it'll stay with the saw. and hopefully not wrap around your wrist. I run an air filter, I've had my shirt sucked into the carb during a run.
Ahh, thanks for clearin that one up for me troutfisher. Seen that, but wasnt exactly sure what it was
That one picture shows a chain adjuster right? that would just be a setup like a regular saw right? Just a threaded rod/screw, with the part that sticks into the bar
I might have a line on a '98 KTM 250cc motocross bike, any advantage/ disadvantages of using a euro engine over a japanese one?
Enter your email address to join: