I got the Partner 540 cleaned up and going, pictures are in the thread I started yesterday.
Today I tore down my Echo CS-900EVL to give it some overdue TLC and then some.
It needed attention pretty bad. I never really done anything to this saw since I got it and the previous owner was running it.
When I pulled the muffler last week to paint it I found the piston was slightly scored so down it came. Pressure and Vac tested it before tearing it all down and found the PTO side seal was leaking like a screen door on a submarine.
Piston could be worse.
Cyl wasnt too bad.
It cleaned up nice and easy. Check out the antivibe mounts beside the jug, they were a mess!
The bench is mess, now to order some parts.
Today I tore down my Echo CS-900EVL to give it some overdue TLC and then some.
It needed attention pretty bad. I never really done anything to this saw since I got it and the previous owner was running it.
When I pulled the muffler last week to paint it I found the piston was slightly scored so down it came. Pressure and Vac tested it before tearing it all down and found the PTO side seal was leaking like a screen door on a submarine.
Piston could be worse.
Cyl wasnt too bad.
It cleaned up nice and easy. Check out the antivibe mounts beside the jug, they were a mess!
The bench is mess, now to order some parts.