I saw it on Ebay/Craigslist

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Oregon chain with "27" on the drivers should be .404-.063G micro chisel chain..........NOT 1/2" pitch. The "30" that's on the cutters is the recommended depth gauge setting........and that also corresponds to .404 chain. My Oregon 1/2" chains are marked "40" for the depth gauge setting. Oregon 1/2" chain that I've seen has been marked "10", "10C", "10S", or "10L" on the drivers...

Chain Saw Chain

Thanks for the sharp eye and correction. I did not dig into it - was just reposting the link, because I know that a lot of guys would like to find 1/2 inch chain.

Caveat emptor!

Philbert

No problem. I sent a message to the seller informing him of the error. He thanked me and corrected the listing title to reflect that it was .404 pitch chain. Still left the description the same (with 1/2" pitch wording) though...
 
Me thinks that's not a 42" bar on the 051. Nice prices though. I'm quite certain guys on here are tripping over themselves to get at the 2.2:msp_w00t:
 
Last edited:
I don't believe so. This seller is a silent saw collector.
Not on any forums that i know of.




Lee

He's a member here and is a good guy to deal with. Unfortunately for him, he's a nice guy who has been taken advantage of by people
over on the collector's site. His saws are always in better condition than described.
 

Latest posts

Back
Top