tacomatrd98
ArboristSite Guru
This is a chainsaw enthusiasts site. This is what we do
Haha, I'm in the same boat...You have a nice 064 that I built that certainly didn't make any sense to, financially or otherwise.
This is a chainsaw enthusiasts site. This is what we do
The 555/560 just feels smaller than the 562xp...
Yes. Ya just need to go and handle both saws. The filter cover and small mount bar are noticeable.Correct me if I'm wrong but I assumed 555 and 562 used same tank and handlebar? is there an actual size difference between the saws other than the air filter cover? If they use the same tank and handlebar the ergonomics would be identical then. I'm not criticizing this mod at all...in fact i'm really intrigued by it. I'm just a little slow and want to fully comprehend the reasons behind it.
On a stock build (conv a 555 to a 560), the throttle response is better. In the cut speed is so close a stop watch and several cuts would be needed. Ported it doesn't seem to matter, both haul ass.Mitch, in your opinion, how critical are the stuffers for optimal performance on a ported saw? A ported 359 sure doesn't miss them.
Thanks for that Mitch. Another thing. I'm not quite clear on the electronic/firmware difference. Is there any advantage to flashing the 555 with 562 firmware, or did you say it's the same? Did you say the difference is actually in the coil?
Enter your email address to join: