Stock carb settings for 051AV?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Canadub

ArboristSite Lurker
Joined
Apr 24, 2017
Messages
10
Reaction score
7
Location
Canada
So I just replaced the piston and cylinder on my 051AV (early model) and I'm trying to get the carb (Tillosten) tuned.

After the replacement, the saw fired right up and idled well, but the first time I pulled the throttle, the carb got stuck open so I pulled the carb off and cleaned it and it's now got the full range of motion again.

However, in the process I definitely adjusted the L and H screws way out of spec. I'm trying to figure out the stock starting point for them to use as a baseline for tuning the carb.

I don't have the 051AV manual (I requested one from the Stihl site some time ago but haven't got it yet) so I can't check there. The TS510 manual looks like it's 1/4L and 1/2H but I'm not sure that's the same carb.

Any experts have some insight?
 
Yes most saws will start and run at 1 L and 1 H then you can fine tune from there.


Sent from my iPhone using Tapatalk Pro
 

Latest posts

Back
Top