I have this old hard nose bar and would like to order a chain for it. Does someone know what chain will fit it?
What chain fits this Stihl bar?
- Thread starter GeorgiaVol
- Start date
Help Support Arborist Forum:
It's 36" .050" gauge, so almost has to be 3/8.
I dont think it is a 36" - more likely this one:
https://www.lsengineers.co.uk/stihl-rollomatic-guide-bar-16-3003-000-8613.html
with a ⅜" chain . . ! and a .050" gauge . . !
Frogfarmer
ArboristSite Operative
16" hard-nose .050 guage. Will be a 60 drive 3/8 or a 67 drive .325 in .050 guage. Hard-nose bars are not pitch specific.
So you can run them in hard and soft wood
.I agree although it does show up as a 3/8 listing in the books.
Thanks guys. That's what I needed to know!
What do you plan on running that one on.
026 or 028
Or maybe a 044
Sounds great.
I think the balance would be a bit off, but it would be fun, especially if it was ported
.
I needed a good test bar before I ordered a nicer one
Duh, I missed the hard nose part.
It will be handy since I can use it on both .325 rims and 3/8 rims.
It's ok Brad, you've got enough teaching all of us a thing or 200 in the bank to cover it lol.
woods works
ArboristSite Operative
Little Al
Addicted to ArboristSite
The OP said it was hard nose, the one you listed was sprocket nose, It is most certainly 050/1.3gauge, the pitch would be dependent on the sprocketI like B Snelling think it's 36"
you can always measure it...
Frogfarmer had the correct bar. I ordered a chain already. Thanks guys
