Bobby Kirbos
Scrounger of Cellulose Based BTUs
My CS-346 idles nicely for a minute or 2, then stops. When I try to restart it, it takes a few pulls before it kicks over and I smell gas. If I'm using the saw, it stays running between cuts with no problem. When I wind it up for the cuts, the throttle response is a bit sluggish.
I suspect the idle screw is set a bit too rich due to the gas smell when it dies while idling. Am I correct??
It performs fine when it is wide open in the cut.
I suspect the idle screw is set a bit too rich due to the gas smell when it dies while idling. Am I correct??
It performs fine when it is wide open in the cut.