Nik's Poulan Thread

[RedneckChainsawRepair]

Pm sent

Got it. Micro series right.

 

[2stroke_shaman]

I want to get a saw small saw for the 4 wheeler. What is the smallest saw that is an upright like the 3400. Old mag case Jr version of the 3400 style. Help me out

I have the soon to run pp325. 53 cc 11# powerhead and 10000 rpm. Will take a 14" bar.

 

[scottr]

Todd , I remember that the 2400 used the same piston and cylinder as the 2300 .

 

[RedneckChainsawRepair]

@jerrycmorrow pic sent

 

[sawfun]

I have the soon to run pp325. 53 cc 11# powerhead and 10000 rpm. Will take a 14" bar.

That PP 325 should go north of 14,000 rpm forget the paltry 10,000. I believe the powerhead is under 11 lbs. as well. These things are a real hotrod, maybe even eclipsing the mighty 346.

 

[2stroke_shaman]

Well here is the official weight as dressed original . #14.10oz might as well be 15# full . Glad to hear more rpm available. I might have to keep it around for a bit . I have not started it . Coil arrives tomorrow.

 

[RedneckChainsawRepair]

PP325 aka partner 5500 is sweet running saws. Keepers IMO. I dont collect saws so I sold my 2.

 

[3000 FPS]

I just remembered you did all of those weights on Chainsaw Repair. Good info!

I think the 335 is my favorite 54cc saw. I have 5 of them. One is NOS never been used.

 

[Todd Loosli]

I would like to see a picture of a new old saw, if anyone has any please

 

[RedneckChainsawRepair]

Some craftsman poulans tagged along with the 660 trade in yesterday. Bare bore 2 thick rings. Along with a cc bang bang.

 

[2stroke_shaman]

Nice craftsman , Im thinkin I want a saw off with these two . The 360 recoil has had better days.

 

[jerrycmorrow]

Got it. Micro series right.

Yes

 

[jerrycmorrow]

Checked compression on the XXV micro today ugh! What is minimum allowable compression ? How much do rings cost?
May not be rebuilding this

 

[2stroke_shaman]

I have a runner with a bad duckbill . Why buy rings and duck with it ?

 

[Todd Loosli]

I had a bad check valve so I made a new one, thing on the left was the prototype

 

[s sidewall]

How well did the prototype work, looks pretty good.

Steve

 

[RedneckChainsawRepair]

View attachment 651119 View attachment 651120 I had a bad check valve so I made a new one, thing on the left was the prototype

Amazing stuff right there. Must be nice.

 

[Todd Loosli]

Anyone need one, 18 shipped .pm. also need some stufff, knob for 3400 air filter hold down could use 4 of them also the outside guide plates for the bar

 

[s sidewall]

You've been busy

Steve

 

[jerrycmorrow]

Checked compression on the XXV micro today ugh! What is minimum allowable compression ? ...

Bump