I know I asked some of this in another thread but I figured this may get some of the builders attn. I plan to use a kit (haven't had much luck finding a OE saw to build on so I bought a farmertec kit) saw with OEM crank/coil/cylinder/piston and use Nachi bearings (I think these are the right ones) with OEM seals/hoses as well as OEM decomp. since I have heard the kit one has issues???
To the builders what specialty tools will I need? guessing something to put bearings into crankcase (althread and washers??) and something to pull the crank into the bearings? I am planning to use Hylomar Blue for gasket sealant. I also have a .013 shim for setting air gap on coil.
What else tool wise should I be looking for?
To the builders what specialty tools will I need? guessing something to put bearings into crankcase (althread and washers??) and something to pull the crank into the bearings? I am planning to use Hylomar Blue for gasket sealant. I also have a .013 shim for setting air gap on coil.
What else tool wise should I be looking for?