Wildland_Firefighter
The Judge
Just bought a belt drive pressure washer that has a Honda GX390 and a General Pump TS1811 pump on it. The pump gives out around 3500 psi and 4.5 GPM.
I've ran the motor and is runs fine but had several leaks (busted hose, and loose connections). I finally got everything fixed and was about to start it today but when I had the water on..the engine wouldn't turn over due to the excess pressure on the pump. I had to turn the water off and then fire up the motor but once I turned the water on...the motor stalled.
What could cause this? Stuck valves or what?
Thanks
I've ran the motor and is runs fine but had several leaks (busted hose, and loose connections). I finally got everything fixed and was about to start it today but when I had the water on..the engine wouldn't turn over due to the excess pressure on the pump. I had to turn the water off and then fire up the motor but once I turned the water on...the motor stalled.
What could cause this? Stuck valves or what?
Thanks