021 new coil and new problem

[boutselis]

I received a coil to replace the the new one that went bad. I put it in and that did the trick. The 021 started right up and ran great......

until it started to heat up. Then gas started to bubble out of the gas tank vent hose and it slowly lost power. I let go of the throttle and it idled for a few seconds and died. It would not start again until it cooled off and then it ran great for a bit till the engine heated up again and then it died.

any ideas on what could be causing that. Thanks for any help.

 

[logging22]

Tank vent? Just my .02.

 

[boutselis]

Tank vent? Just my .02.

The tank vent is clear. At least it is if it is just the little hole with a shor piece of tube attached to it. After the saw warms up gas starts bubbling out of it.

I can't figur out why

 

[logging22]

The tank vent is clear. At least it is if it is just the little hole with a shor piece of tube attached to it. After the saw warms up gas starts bubbling out of it.

I can't figur out why

And thats a new one for me also. Got some members here that will know, just give them a minute. Welcome to AS!

 

[boutselis]

And thats a new one for me also. Got some members here that will know, just give them a minute. Welcome to AS!

thanks