17fireball
ArboristSite Lurker
I need a little advice on a perplexing problem with my 024. I can't seem to get my low idle adjusted correctly. The saw starts cold after 2-3 pulls and idles in the 26-2800 rpm range. As the saw warms up the idle drops and i can only keep the saw running by blipping the throttle. Another interesting symptom is that when I set the saw down on a hard flat surface the idle increases. When I pick the saw up and carry it by the handle the idle starts to die. Here's what i have done to the saw: Vac check- holds well no leaks. New fuel line, filter, impulse line. Carb has been rebuilt with a Tillotson kit. Compression on the saw is 120-125 psi cold.